The result is not bad at all we only have just two minor issues:
- pin 4 of the DIP switch was not connected to the board solder island (re solder)
- led order is not parallel with power outlets (can be mapped in software)
I'm now started with converting my proof of concepts I did on the olimex board to our brand new board. I test every block code as I move on. Small video below shows the testing of the timers. At the moment this not yet synchronized with the zero cross and FIR it just tests the timers and nvic module. Next step will be testing the ADC and FIR for the zero cross detection.
Also the button test board (see picture) is now connected so we have a nice test kit for 12 in and outputs. Having these helper tools is indispensable as preparation for the final production release.
Button test board:
Power test with timers:
No comments:
Post a Comment